MFlenses — новая жизнь в цифровую эпоху
MFLenses 2026

Форум объективов с ручной фокусировкой

Исследуйте мир старых объективов через заметки о ремонте, реальные тестовые снимки и подробные архивные темы с множеством изображений.

Исследуйте мир старых объективов через заметки о ремонте, реальные тестовые снимки и подробные архивные темы с множеством изображений.
В центре внимания

Место для партнёра на главной странице форума.

Step by step resassembly of the Ihagee original EXA - III
Предыдущая тема :: Следующая тема  


Reply

After some cleaning of all the debris and old lubricants, the reassembly follows the same steps in reverse, the final result look much cleaner than before:

#1 The shutter base looks clean, now the reassembly can start.



#2 Even the spacers look shiny.



#3 Install the left wing where the shutter lever goes.



#4 When placing this part, be careful of pressing the spring end behind





#5 Now place the shutter speed lever elements. There is a small spring wire that might be low of tension, adjust accordingly.





#6 Next place the shutter trigger lever and over it the mirror retainer.



Finally, place the two levers at the bottomside.
With this, we have again a working shutter mechanism.


Jes.


Reply

Wow! It is really clean! I can't wait for final result, how you can make from an orphan camera a new proud guy again!


Reply

We will name this camera 'Oliver' Very Happy

Looks much better in the reassembly than it did in the disassembly stage.


Reply

Laughing


Reply

maddog10 писал(а):
We will name this camera 'Oliver' Very Happy

Looks much better in the reassembly than it did in the disassembly stage.


Good name!. It will keep it Smile.

Jes.