MFlenses — новая жизнь в цифровую эпоху
MFLenses 2026

Форум объективов с ручной фокусировкой

Исследуйте мир старых объективов через заметки о ремонте, реальные тестовые снимки и подробные архивные темы с множеством изображений.

Исследуйте мир старых объективов через заметки о ремонте, реальные тестовые снимки и подробные архивные темы с множеством изображений.
В центре внимания

Место для партнёра на главной странице форума.

Did you know that superglue is an insulator?
Предыдущая тема :: Следующая тема  


Reply

Tried to make a 4,5 v battery from 1,5 v cells. It really creates a minimal layer between.

Does the cell explode if I drop a small drop of solder on it?


Reply

If solder drop shorts battery it will heat fast and possibly explode. Applying enough heat trying to melt solder on terminal takes big solder iron at least 100Watts, not too long, to prevent overheating and damage battery. Suggest purchase batteries with solder terminals already or ready-made pack. Otherwise there is conductive epoxy available.


Reply

Yes I did Very Happy made that mistake myself! I put washers between the cells if they need spacers and then put masking tape around the batteries to join them in a tube like way. Not sure about the solder, could be a problem never tried that.


Reply

You're using tin/lead alloy, right? Melting point is about 180 to 230 degrees depending on the composition, so there is a fair chance you'll heat up the lithium cell above it's working temperature possibly causing it to explode.

Never boiled lithium cells but I've once popped an alkaline battery in outdoor strobe use use (inside a flash gun). Alkalines crackle-pop at about 90 degrees I was told by the flash repairman.

Can you fit a cell holder around them, to connect them? I'd strip one off an old calculator or similar device. Another option would to use solder tabs, they'll take off most of the heat from the drop. http://www.bebek.fi/myymalat.php

If you go for it I recommend solding it with gloves under a glass cupola, wearing protective gear...


Reply

When making up battery packs I've soldered wires onto old carbon-zinc, alkaline, NiCad, and NiMh cells with no problems at all. Just don't leave the iron in contact for too long - a 25W iron is just about adequate, but a soldering gun http://en.wikipedia.org/wiki/Soldering_gun is better if you're quick.
So far I've not had one blow up in my face, but Esox is right to be cautious about lithium cells, imo.
Otoh, if rechargeables will do, you can easily get tagged cells if you check out the electronic and model car/plane/boat hobbiest suppliers' sites.