MFlenses — новая жизнь в цифровую эпоху
MFLenses 2026

Форум объективов с ручной фокусировкой

Исследуйте мир старых объективов через заметки о ремонте, реальные тестовые снимки и подробные архивные темы с множеством изображений.

Исследуйте мир старых объективов через заметки о ремонте, реальные тестовые снимки и подробные архивные темы с множеством изображений.
В центре внимания

Место для партнёра на главной странице форума.

Err 80 5DMK2
Предыдущая тема :: Следующая тема  


Reply

.

I transferred a CF card taken with other 5DMK2 and now my unit halted. Without card it works fine, if I use one of both of my cards, it says Err 80. Both of the cards can't be damaged, or odds are low at least.

I have taken battery off and it resets until I put card in. If I take card out, it still says Err80, until I do a battery reset.

And service number is....


Reply

Have you tried formatting the card on your computer, and then putting it in the camera and formatting in the camera options as well?

You can also try the Error checking function on windows computers.
My Computer > Right click your CF card > Properties > Tools > Error checking


Reply

My computer reads every other card but not CF...


Reply

Exchange of cards from two different cameras -- has been successful in past? Problem with card on other camera now too?

Take a look in camera CF slot maybe bent pins.


Reply

I took a look and looked it and found nothing wrong.
I took another look, and found something that could be something. I straighten it carefully and voila, it works.

God bless you guys.


Reply

For this exact reason I always recommend usb cable instead of reader; slower yes, but usb connector is much more durable, designed for multiple connect-disconnects, than cf pins... Wink

Very HappyVery HappyVery Happy Always nice to hear good news!


Reply

This is also a reason that when I use a camera with a CF card, I always plug the CF card in with a tiny amount of force.


Reply

I've been using CF cards since my Kodak P&S back in 1999. I've yet to have one fail. You just need to be careful.


Reply

visualopsins писал(а):
For this exact reason I always recommend usb cable instead of reader; slower yes, but usb connector is much more durable, designed for multiple connect-disconnects, than cf pins... Wink


I think CF slots should be rated for a high number of insertion cycles too. Otherwise CF readers would be broken quite quickly too. I don't bother with plugging my 5D into USB too slow and annoying to open that rubber flap on the side. Never had a problem with my 5D and 40D...


Reply

AhamB писал(а):
visualopsins писал(а):
For this exact reason I always recommend usb cable instead of reader; slower yes, but usb connector is much more durable, designed for multiple connect-disconnects, than cf pins... Wink


I think CF slots should be rated for a high number of insertion cycles too. Otherwise CF readers would be broken quite quickly too. I don't bother with plugging my 5D into USB too slow and annoying to open that rubber flap on the side. Never had a problem with my 5D and 40D...


I think so too. Care is necessary on insertion -- push slowly into slot until card reaches pins, then use gentle yet firm pressure to fully seat card onto pins. Careful as I am I have put the card in upside down more than once; jamming would surely have bent or broken some pins. I think some people just jam 'em in there. I hear more about bent cf pins than broken usb connectors.


Reply

That was an user error. I was doing many different things at same time.