MFlenses — новая жизнь в цифровую эпоху
MFLenses 2026

Форум объективов с ручной фокусировкой

Исследуйте мир старых объективов через заметки о ремонте, реальные тестовые снимки и подробные архивные темы с множеством изображений.

Исследуйте мир старых объективов через заметки о ремонте, реальные тестовые снимки и подробные архивные темы с множеством изображений.
В центре внимания

Место для партнёра на главной странице форума.

FED2 and a Jupiter-12
Предыдущая тема :: Следующая тема  


Reply

I am hoping for some help here!

As some of you may remember I was given a nice FED2 with a Industar-26m lens for Christmas. It worked very nicely and I was happy.

I just won a Jupiter-12 35mm f/2.8 lens on ebay. Annoyingly, I cannot get the lens to mount. The rear lens cap fits both the Industar and the Jupiter quite happily, but the Jupiter just goes round and round in the throat of the camera and the threads do not catch.

Any ideas what may be wrong?

Many thanks, Kris.


Reply

Sometimes hard to screw in , try at both position infinity and shortest too.

Another possible problem is rangefinder adjust arm , if not fully in right position you can't screw in J-12 this did happen with me with my Fed-3a what is basically exactly a FED-2.Either you can try to adjust it or by another FED-2 body.


Reply

set the lens at closest focus. this will keep the rf arm from pushing against the helicoid, and might make it easier to screw in..