MFlenses — новая жизнь в цифровую эпоху
MFLenses 2026

Форум объективов с ручной фокусировкой

Исследуйте мир старых объективов через заметки о ремонте, реальные тестовые снимки и подробные архивные темы с множеством изображений.

Исследуйте мир старых объективов через заметки о ремонте, реальные тестовые снимки и подробные архивные темы с множеством изображений.
В центре внимания

Место для партнёра на главной странице форума.

Bad M42 adapter?
Предыдущая тема :: Следующая тема  


Reply

This is shot with a Vivitar 28 2.5 at f8. Shot is at infinity. I think the adapter is to thin and it's going past infinity. I have other shots I can post if it helps.This is the Kiron version.
Tell me what you think.



Reply

I've never owned an M42 adapter that stops the lens at infinity! I think manufacturers prefer them to go slightly past infinity, to counter any issues around changing temperatures. Or they're just rubbish at getting the right thickness Laughing


Reply

ManualFocus-G писал(а):
I've never owned an M42 adapter that stops the lens at infinity! I think manufacturers prefer them to go slightly past infinity, to counter any issues around changing temperatures. Or they're just rubbish at getting the right thickness Laughing


+1 and adapter maker usually make adapters to pass infinity, to buyer send them back if not reach infinity with a lens. Buyers not really care trouble maker is lens not the adapter.

My Pixco adapters for Sony-NEX, m4/3 all pass infinity , need to set all of my lenses to a few mm before infinity mark. Kiwi made Samsung NX adapters I have two of them reach infinity exactly at infinity mark.


Reply

It is possible to keep the lens stops exactly at the infinity mark if and only if:

camera register distance + adapter thickness = register distance of the adapted lens

If the difference of the value in both side is less than 0.02mm, the lens should stop at the exact/near exact infinity position. High quality adapters made will have a tight tolerance so they will allow more lens reach infinity exactly at infinity mark but they are much expensive than the mass produced budget adapters.


Reply

calvin83 писал(а):
It is possible to keep the lens stops exactly at the infinity mark if and only if:

camera register distance + adapter thickness = register distance of the adapted lens

If the difference of the value in both side is less than 0.02mm, the lens should stop at the exact/near exact infinity position. High quality adapters made will have a tight tolerance so they will allow more lens reach infinity exactly at infinity mark but they are much expensive than the mass produced budget adapters.


Less than 0.02mm for wide angle lens -- distance variation with shorter focal length lens has more effect than with longer focal length.

Some lenses focus past infinity anyway, to provide a compensation range for temperature-related dimensional changes of optics & mechanics.


Reply

Thanks everyone.I also noticed but didn't mention that the lens goes past the 12 oclock position. I might try to shim it and recheck it.
I will pickup a battery for my digital caliper so I can check the exact thickness of the adapter.