MFlenses — новая жизнь в цифровую эпоху
MFLenses 2026

Форум объективов с ручной фокусировкой

Исследуйте мир старых объективов через заметки о ремонте, реальные тестовые снимки и подробные архивные темы с множеством изображений.

Исследуйте мир старых объективов через заметки о ремонте, реальные тестовые снимки и подробные архивные темы с множеством изображений.
В центре внимания

Место для партнёра на главной странице форума.

Two basic film questions for my camera
Предыдущая тема :: Следующая тема  


Reply

Hi two very basic thinks.
1. I have a iso 3200 black and white film. My camera support in the metering only 1600. I can set though the exposure compensation dial but I always get confused.. Iso 3200 is iso 1600 +1 or -1 in my exposure compensation dial?
2. If I want to push my hp5 iso 400 film to iso 800 ... I just shoot it as iso 800 and then do the rest during development. Would not that be right?

Regards
Alex


Reply

1. You would use -1 EV compensation. But it really doesn't matter much.

2. That's correct. Essentially you underexpose and overdevelop.Alternatively you could look into a technique called stand development. In that case it doesn't matter which film you use, what ISO, how much under or overexposure, etc., you just put the film into a very thin solution of developer and leave for an hour or so and it comes out right.


Reply

You can shoot it at 1600 pull process one stop. The DigitalTruth Massive Development Chart will have directions for that.

Delta 3200 at 400 ISO is a fantastic combination. I haven't tried it at 1600.


Reply

But to answer your question a different way, if your meter reading at 1600 says f5.6 and 1/125th, then to shoot at 3200 simply set your shutter speed to 1/250th. 3200 is one stop faster than 1600 so you need to cut the amount of light in half.


Reply

miran писал(а):
1. You would use -1 EV compensation. But it really doesn't matter much.

2. That's correct. Essentially you underexpose and overdevelop.Alternatively you could look into a technique called stand development. In that case it doesn't matter which film you use, what ISO, how much under or overexposure, etc., you just put the film into a very thin solution of developer and leave for an hour or so and it comes out right.


1. Why it does not matter?
2. Sounds intresting and very nice for a lazy guy like me. I guess it should also have lot of negatives...

Alex


Reply

1. Film has such huge latitude you can easily compensate for that 1 stop with development or when scanning (I assume you scan).

2. No negatives. The only thing is that contrast will be potentially much lower, the negative will look quite flat. This would be important if you were printing traditionally with an enlarger, but because you're scanning digitally this is actually a good thing. You can put more contrast in during scanning or post production, it's much more difficult to take it away.


Reply

Rolling Eyes someone mentioned stand developing to Alex... Wink