MFlenses — новая жизнь в цифровую эпоху
MFLenses 2026

Форум объективов с ручной фокусировкой

Исследуйте мир старых объективов через заметки о ремонте, реальные тестовые снимки и подробные архивные темы с множеством изображений.

Исследуйте мир старых объективов через заметки о ремонте, реальные тестовые снимки и подробные архивные темы с множеством изображений.
В центре внимания

Место для партнёра на главной странице форума.

Problem with Plustek 7500i SE
Предыдущая тема :: Следующая тема  


Reply

Hello Folks,

This may (or may not) be a problem with my Plustek 7500i SE.

Here's the problem.

I scan successfully but have some very small lines going across the page diagonally,
which when I enlarge the picture these lines are actually words, saying 'Arc Soft Laser Imaging'.

And I can't seem to remove them. Is this because I am using the scanner in 'demo' mode?

It asks for the 'product key' for Windows 7, which I do not have - it's a 25 digit number usually found
on the rear of the laptop - it is there but can not be read because it has worn off. So I do not enter the
'product key'.

My question is: Is not putting in the product key number causing the scanner to be only available in 'demo' mode,
and is this in turn causing the diagonal lines of 'Arc Soft Laser Imaging' across the scanned image?

Has anyone had the same problem, and do you have a solution please?

Kind regards, and a belated Happy New Year to you all...Paul.


Reply

ArcSoft does produce some imaging software. I think you have a trial copy of some ARCSOFT application. http://www.arcsoft.com/index.html. I don't think they have scanner software, but maybe the scanner is sending the files to an editing program. Look in your programs directory to see if you have an ARCSOFT directory, and what software is there. Also look at your scanner application. If you have purchased an application then it just needs registration.

I use VUESCAN, which is configured to open my scan files in Irfanview.

Just my thoughts,

Phil