MFlenses — новая жизнь в цифровую эпоху
MFLenses 2026

Форум объективов с ручной фокусировкой

Исследуйте мир старых объективов через заметки о ремонте, реальные тестовые снимки и подробные архивные темы с множеством изображений.

Исследуйте мир старых объективов через заметки о ремонте, реальные тестовые снимки и подробные архивные темы с множеством изображений.
В центре внимания

Место для партнёра на главной странице форума.

Springs!
Предыдущая тема :: Следующая тема  


Reply

Is anyone aware of a source for the tiny springs used behind focus ring click-stop ball bearings. Sad


Reply

And the ball bearings too?


Reply

Balls are no problem. Easy to find on ebay. Usually sold in different sizes in packets of 10 or so, all for pennies, free shipping from China or Hong Kong. As for tiny springs, I don't know. Maybe also available from the same chinese sources?


Reply

Thanks for the replies,Ball bearings I have sourced.Springs wise there is a supplier of Micro-springs on Ebay I have found.JUst specify dimensions etc.Sold as packs of 20 .


Reply

Who need click stops Wink


Reply

I could use a source for small springs as well. I'm missing one that's about 2mm in diameter and about 4mm long that is used to engage the slow speed escapement on my Pentax MX. Without the spring, I don't have speeds slower than 1/15.


Reply

I was also looking for some. My plan is to try McMaster-Carr (in USA, https://www.mcmaster.com/#compression-springs/=17b8bxn), since they seem to have some that can compress to around 2mm which might be enough or it might be possible to shorten them.

If a vendor like that doesn't cut it, you might want to look into making your own. I found this introduction video pretty useful: https://www.youtube.com/watch?v=jAawhg6JtyY