MFlenses — новая жизнь в цифровую эпоху
MFLenses 2026

Форум объективов с ручной фокусировкой

Исследуйте мир старых объективов через заметки о ремонте, реальные тестовые снимки и подробные архивные темы с множеством изображений.

Исследуйте мир старых объективов через заметки о ремонте, реальные тестовые снимки и подробные архивные темы с множеством изображений.
В центре внимания

Место для партнёра на главной странице форума.

What about the rust?
Предыдущая тема :: Следующая тема  


Reply

I took the Super Ikonta to a workshop in Bologna for defungusing. But what about the rust? This I will have to fix myself. Is there any suggestion that you can give me? How to remove the rust, how to stop it from progressing?
Any advice is welcome.


Reply

There are different chemicals used for anti-rust coatings, but I have never heard of one of those being used for photographic gear, rather boats and the like...


Reply

Orio писал(а):
I took the Super Ikonta to a workshop in Bologna for defungusing. But what about the rust? This I will have to fix myself. Is there any suggestion that you can give me? How to remove the rust, how to stop it from progressing?
Any advice is welcome.


How bad is the rust and where is it? For general rust cure I use Phosphoric Acid - it turns the rust into Iron Phosphate which is fairly inert and protects the underlying metal from further corrosion. If it's just surface rust it can be cleaned off with emery cloth and then polished up.


Reply

Farside писал(а):

How bad is the rust and where is it?


It is mostly on the frontal port, the one that opens to let the lens and bellow out.
It is quite bad it seems, but it should not be in direct contact with any camera mechanism, only exterior.

Farside писал(а):
For general rust cure I use Phosphoric Acid - it turns the rust into Iron Phosphate which is fairly inert and protects the underlying metal from further corrosion.


How do you apply it, is it possible to brush it?

Farside писал(а):
If it's just surface rust it can be cleaned off with emery cloth and then polished up.


Ok I'll try this first, what is emery cloth, is it like sandpaper?


Reply

Orio писал(а):
Farside писал(а):

How bad is the rust and where is it?


It is mostly on the frontal port, the one that opens to let the lens and bellow out.
It is quite bad it seems, but it should not be in direct contact with any camera mechanism, only exterior.

Farside писал(а):
For general rust cure I use Phosphoric Acid - it turns the rust into Iron Phosphate which is fairly inert and protects the underlying metal from further corrosion.


How do you apply it, is it possible to brush it?

Farside писал(а):
If it's just surface rust it can be cleaned off with emery cloth and then polished up.


Ok I'll try this first, what is emery cloth, is it like sandpaper?



You can brush the acid on, no problem. I use a 15-25% solution. If you can't get it, a good source of supply is a farmer supply place. Have a look at this ....

http://www.totallytriumph.net/dcforum/DCForumID43/21.shtml#1

Emery board and cloth is like sandpaper, but is carborundum (silica carbide) grit on it - available in different grit sizes. You will find that in any hardware or car repair parts shop. You will need a very fine sheet, I'd think.