MFlenses — новая жизнь в цифровую эпоху
MFLenses 2026

Форум объективов с ручной фокусировкой

Исследуйте мир старых объективов через заметки о ремонте, реальные тестовые снимки и подробные архивные темы с множеством изображений.

Исследуйте мир старых объективов через заметки о ремонте, реальные тестовые снимки и подробные архивные темы с множеством изображений.
В центре внимания

Место для партнёра на главной странице форума.

What causes this:
Предыдущая тема :: Следующая тема  


Reply

Hi guys, I recently came across a Yashica D and have been using it religiously. Occasionally, though, I run into a strange problem and I can't figure out what has been causing it. Here's an example:


In some photos, like this one, I get a strange light problem, almost like a flare. Is it a flare? In the case of photo I don't mind it too much, but as you can see, it covers most of the bottom of the photo and some of the sides. Is it just a flare or is there something wrong with the camera?

Also, here's one more thing that might or might not be related:



What causes that? It usually seems to occur when there's a light in the corner (for instance in this case I think the sun was up there). Something wrong with the camera?

Thanks!


Reply

It could be a light leak in the camera.
I have a hunch that it is actually some fogging that occurs when loading the film.
Try loading in a very dim space. Loading the TLR's can be a bit clumsy I have found.
It is not difficult to allow light to fog the film by accident.


Reply

Thanks for the reply. Is there anyway to fix the light leak? It only occurs sometimes. I'll try to be more careful loading the film, but it only seems to affect certain frames, which is odd.


Reply

I'm no expert, especially where film is concerned, but I would vote for flare. The sun is clearly front-right in that photo, which would be just the position to give flare like that. I would guess it was so bright that it is also responsible for flooding the corner of the film outside the frame (maybe some sort of light transmission through the emulsion .. just a wild stab in the dark).

Try to avoid strong backlighting, it is causing your subject to come out under-exposed as well as causing flare. If you want rim-lighting on the hair you need to have a light source in front as well as behind (unless you are after a pure silhouette).

ANOTHER THOUGHT: Are you using a lens hood? It is highly recommended, as in this advice I just found: "Using a lens hood with your Yashica is a must. Not using one often results in lower contrast pictures. Best is to look for a Bay-1 Hood such as the older Rolleiflex type Bayonet. Filters and Close-Up lenses can also be used, just make sure you'll get a Bay-1 version. "


Последний раз редактировалось PaulC Ср Янв 28, 2009 7:49 pm; всего правок: 1


Reply

PaulC писал(а):
I'm no expert, especially where film is concerned, but I would vote for flare. The sun is clearly front-right in that photo, which would be just the position to give flare like that. I would guess it was so bright that it is also responsible for flooding the corner of the film outside the frame (maybe some sort of light transmission through the emulsion .. just a wild stab in the dark).

Try to avoid strong backlighting, it is causing your subject to come out under-exposed as well as causing flare. If you want rim-lighting on the hair you need to have a light source in front as well as behind (unless you are after a pure silhouette).


Thanks for the reply! I certainly think it's possible that it was a flare due to the harsh lighting. I'll watch out for that next time.


Reply

I just added a line to my previous post about lens hoods...


Reply

Thanks a lot Paul! I'll definitely look into getting a lens hood. Smile


Reply

Yep, that could be a simple flare problem. If your seals were bad you would have a consistent image problem. ( Red streaking and such. )

Although, it is a good idea to have your seals replaced on older cameras. It's cheap.

Here's a CLASSIC light leak:


Here's another nice light leak:



Reply

I also have a Yashica D & the first thing I did was to purchase a hood. Be careful as the cheap plastic ones won't allow you to use any filters while the hood is on. Try to find an original one or at least one that attaches to the outside of the lens